Stories. Questions. Different perspectives.
Browse WAURE
← Advice & Questions
Technology · Advice & Questions ·

Why does my continuous-rotation servo keep turning instead of stopping at an angle?

Technology category photographTechnology

I wanted a cardboard display pointer to move to a marked position. The small motor was advertised as a continuous-rotation servo, which sounded like a more flexible version of a standard servo. In the example controller, changing the value changes its turning behaviour, but doesn't make it hold my mark.

Adafruit distinguishes continuous-rotation servos, which control rotation speed, from standard positioning servos. Adafruit's servo explanation

The pointer isn't attached yet. Have I chosen the wrong kind of movement for this project, or is there a sensible way to reach repeatable marked positions with the parts I have? I would prefer to change the plan now than build the display around a mistaken assumption.

Discussion

5 community replies

“Continuous” describes a different behaviour here, not an unlimited positioning range. Adafruit explains that this kind of servo cannot be commanded to a particular location in the way a standard positioning servo can. Start by deciding whether your display needs position or continuous motion.

If the point is to indicate one of several labels, write down the required travel and how accurately it must stop. Those requirements will help you choose a suitable mechanism. The existing part being small and already paid for doesn't establish that it meets them.

You could redesign the display around something that turns, rather than force this part into a pointer role. That is a creative option if the moving display itself matters more than showing a precise label.

Timing a burst of rotation might produce an approximation, but I'd be cautious about calling it repeatable positioning without feedback. Test the required behaviour over repeated moves before committing the artwork and linkage to it.

Include where the pointer starts in that test. A routine that appears to work from one hand-set starting mark hasn't established how it will find the same labels after an interruption. If recovering a known position matters, make that part of the design requirement.

Join the discussion

More in Technology